Fixes issue that causes a Gate Driver Fault if the NEO is spinning at a certain speed during power up.Previous Firmware Change Log - Version 1.1.33 Adds ability to change units for arbFF between voltage and percent bus voltage (or percent compensated voltage).Fix for Follow settings not being reapplied after power cycle.Adds additional filtering to bus voltage.Additional accuracy improvements to all ADC measurements.Fix to bus voltage measurement, previous version reported a lower value.Future versions will allow recovery over CAN. This is not yet integrated into a formal tool, but is exposed in the API.Requires continuous power during update and requires USB recovery if the update fails after erasing the flash (i.e.Adds initial CAN bootloading functionality.Adds status 3 periodic frame for analog sensor.Fixes issue where sticky faults can be cleared incorrectly when a new fault is set and the old fault is no longer present. Smart Motion now honors acceleration rate after limit switch changes from triggered to not triggered.All control modes now reset integrator on limit switch activation for long as the limit switch is held.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |